Large tiles in a small bathroom: yes or no?
Large tiles usually make a small bathroom look bigger: fewer grout lines, calmer walls. The catch is the shower floor, which must slope to the drain. Use a linear drain or smaller tiles in the shower, and check the slip rating.
Why large tiles work
A wall of 600 × 1200 mm tiles in a 2.4 m high bathroom has only one or two horizontal grout lines; the same wall in 100 × 100 mm tiles has twenty-four. Fewer lines read as one surface, so the room looks bigger and calmer, and there is less grout to clean. Running the same tile on floor and walls makes the effect even stronger.
| Tile | Common uses | Grout lines in a 2 m wall run |
|---|---|---|
| 100 × 100 / mosaics | Shower floors, feature niches | About 20 |
| 300 × 600 | Walls and floors | About 3 to 7 |
| 600 × 600 | Floors and walls | About 3 |
| 600 × 1200 | Walls and floors | About 1 to 2 |
| Slabs (1200 × 2400 +) | Feature walls, vanities | 0 to 1 |
The shower floor problem
A shower floor must fall towards the drain. With a centre drain, the floor slopes in four directions like a shallow funnel, which needs cuts in a large tile (envelope cuts) or small tiles that follow the slope. A linear (strip) drain along one wall lets the floor fall in one direction only, so a large tile can run flat across it. Many bathrooms use the large tile everywhere and a matching smaller tile or mosaic inside the shower.
Slip resistance
Floor tiles are rated for slip resistance in Australia with a P rating (P0 to P5), measured with a pendulum test. Bathroom floors usually need a higher rating than living areas, and shower floors higher again, especially for children and older people. Ask the supplier for the rating, and avoid polished tiles on a wet floor. Large matt tiles with a suitable rating are widely available.
What the tiler needs
- A flat substrate: large tiles show every hump; walls and screeds must be very flat.
- Levelling clips to avoid lippage (one tile edge higher than the next).
- More adhesive and back-buttering, so labour costs more per square metre.
- Two people for 1200 mm tiles, and care getting them into the room.
- A set-out: where the cuts fall, so you don’t get thin slivers at a wall or around the toilet.
Layout tips
- Line up grout joints across floor and walls where you can.
- Centre the tiles on the most visible wall, like the vanity or the shower.
- Lay long tiles horizontally to widen a room, vertically to add height.
- Keep the grout close to the tile colour for the calmest look.
Cost and waste
Large tiles often cost more per square metre, take longer to lay, and waste more in small rooms because every cut leaves a big offcut. Order 10 to 15 percent extra and keep a few spares for repairs. See the tile calculator.
Questions
Do large tiles make a small bathroom look bigger?
Usually yes: fewer grout lines make walls and floors read as one surface.
Can you use large tiles on a shower floor?
Yes, with a linear drain so the floor falls one way; otherwise use smaller tiles in the shower.
What slip rating do bathroom floor tiles need?
A higher P rating than dry areas, and higher again in showers. Ask the supplier.